OEM REFRIGERANT SENSING INTEGRATION

Integrate Refrigerant Detection into HVAC/R Equipment

Provide refrigerant sensing inputs for the equipment’s defined protection strategy.

MAXMAC supports OEM integration of R2 R290 sensors and R3 R744 sensors into heat pump and refrigeration controls. Bring module placement, power, communication and the host response together during equipment development.

Discuss Your Application →
HVAC/R Equipment Safety Integration engineering illustration with refrigerant equipment and gas sensing components

APPLICATION BENEFITS

Refrigerant Sensing Built Around Your Equipment

Combine sensor selection with mechanical integration, controller communication and evaluation in the finished equipment.

01

Mechanical Integration

Review gas access, mounting space and environmental conditions so the selected sensor fits the equipment layout.

02

Power and Communication

Match the module’s supply and supported interface to the equipment main board, with configuration support for OEM requirements.

03

Host-Controlled Response

Provide concentration inputs for the equipment controller’s alarm, ventilation or shutdown strategy.

04

Standards and Validation

Review applicable IEC and UL requirements, including 60335-2-40 for heat pumps and air conditioners and 60335-2-89 for commercial refrigeration, alongside equipment-level validation.

Equipment main control board diagram showing selected sensing inputs and project-defined equipment response
Illustrative integration concept. Modules, sensing locations and system responses are selected and validated for each project.

MODULE, MAIN BOARD & EQUIPMENT

Plan the Full Integration Path

Bring R290 propane detection or R744 CO₂ monitoring into the equipment design. MAXMAC supports module selection and configuration while your equipment controller defines how measurements inform the system response.

  • Module position and gas accessReview leak paths, airflow, enclosure openings and service access in the actual equipment layout.
  • Power, wiring and communicationMatch the selected supply and standard RS485 interface to the main board. LIN 2.1 or CAN customization is reviewed against project requirements.
  • Main control board responseSpecify how the host uses concentration data and handles unavailable readings, communication faults and recovery.
  • Validation and applicable standardsEvaluate the installed response, environmental conditions and control behavior against the requirements for the equipment and target market.
Explore the R290 HVAC/R Solution

MEASURE, COMMUNICATE & VALIDATE

From Sensor Integration to Validated Equipment Response

The sensing module supplies measurements; the host controller evaluates them and the installed equipment implements the defined response.

  1. 01

    REFRIGERANT MODULE

    Measure

    Measure the target refrigerant with the selected R2 or R3 configuration.

  2. 02

    CONTROL INTERFACE

    Communicate

    Transmit measurements through the selected supported module interface.

  3. 03

    COMPATIBLE CONTROLLER

    Evaluate

    Use the host controller’s defined measurement, threshold and fault-handling logic.

  4. 04

    CONNECTED HVAC

    Respond

    The equipment carries out the selected protective action according to its validated design.

  5. 05

    SENSOR + CONTROLLER

    Validate

    Verify the defined system response, ongoing measurements and recovery conditions.

Ongoing measurement

EQUIPMENT DESIGN INSIGHTS

R290 HVAC Design: Leak Paths and Sensor Placement

How does using R290 change refrigerant routing, the equipment safety boundary and sensor placement? Explore the design considerations that connect a sensing module with the finished HVAC system.

Read the R290 HVAC Design Guide

For an overview of MAXMAC sensing and integration support, explore our R290 HVAC/R solution.

HVAC equipment used to explain R290 leak paths and sensor placement

Discuss Your Equipment Integration Project

Share your equipment layout, operating conditions and control requirements. Our team will help you review sensor options and integration needs.